top of page
Sheet Piles ESC CFW Series

ESC-CFW Series

Cold Formed Sheet Piles

The ESC CFW series was developed to enable a wide profile sheet pile to be produced economically without any requirement for interlock clutch welding. ESC-CFW sheet piles have excellent driveability due to the interlock design. A large range of sizes and strengths can be designed. The manufacturing process gives full flexibility in the profile design allowing features such as corner piles, tapered piles. 

Sheet pile CFW Series drawing
Section Modulus Range

710-4000cm3/m

Width Range (single)

805-1162mm

Thickness Range

​5.75-11.75mm

Production Standards

​BS EN 10249 Part 1 & 2

​Steel Grades
  • Q235B, Q345B, Q345C, Q390B, Q420B

  • S235, S275JR, S355JR, S355JO

  • ASTM A572 Gr42, Gr50, Gr60

  • Others available on request

Length

14.0m maximum 
Longer lengths can be spliced (>30m possible)
Any project specific length can be produced

Delivery Options
  • Lifting Hole

  • Grip Plate

  • By container (11.8m or less) or Break Bulk

  • Corrosion Protection Coatings

Corner Piles

Due to the flexibility of the forming process, the ESC-C-CFW Series Sheet Piles can be formed to almost any corner configuration, without requiring any wastage or welding. Note that the interlocks should be orientated toward the retained side as shown in the following figures.

Technical Information

Technical Information

Product Images

Product Photos

Product Case Studies

Case Studies
bottom of page